This method describes how to evaluate the degree of contamination or the purity of malt as part a manual inspection procedure.
Malt intended for use in beer brewing or elsewhere in the food industry.
Visual examination of malt for foreign objects. Refer to the Sieving Test for Malt (R-200.08.011).
Whole hops intended for use in beer brewing or elsewhere in the food industry
Evaluation of the appearance of hop cones is performed through visual and manual inspection.
Determination of the fermentation cellar yield in order to monitor brewhouse operations
Wort from the midpoint of chilling/pitching wort
The fermentation cellar yield is calculated using the value determined for the amount of extract contained in a batch of wort relative to the amount of extract present in the raw materials used to produce the wort.
The gelatinization temperature can be determined using a rotary viscometer (e.g., Amylograph or Viscograph, Brabender GmbH & Co. KG, Germany [4] or a Rapid-Visco-Analyser, RVA, Perten Instruments, a PerkinElmer Company, USA [8]).
A suspension consisting of a finely ground sample and water is produced, whose precise mixing ratio should correspond to the analysis protocol for the adjunct in question. However, since for many cereals and pseudocereals no official analysis protocol exists, the initial weight for the adjuncts listed in table 2 has been determined empirically [3].
Once the suspension is prepared it is attempered according to a pre-programmed temperature/time program, and the viscosity is determined on a continuous basis by means of a rotor and a rotary torque measurement (fig. 1). When gelatinization begins, an increase in the viscosity is registered, and the corresponding sample temperature is defined as the gelatinization temperature. The standard evaluation criterion (PT) is a viscosity increase of at least 24 cP (≙ mPas) within six seconds.
Barley intended for the production of malt is to be evaluated on the basis of the characteristics described below.
visual assessment
This method describes how to determine whether kernels are cracked as part of the visual and manual inspection of a lot of barley.
Barley intended for the production of malt is to be evaluated on the basis of the characteristics described below.
Visual assessment