Production facilities in the beverage industry which fill beverages in containers with crown cap or pull-off closures
Bottles are filled with mineral water and sealed with crown caps or pull-off closures to be tested. The samples are subjected to treatment in a light cabinet and subsequently tasted against a reference sample.
Production facilities in the beverage industry which fill beverages in containers with roll-on or screw cap closures
The closure should have no sensorial impact on the aroma or the flavor of products packaged in the bottles.
This is applicable for the following: aluminum roll-on closures without safety features used for sealing returnable and disposable glass bottles with threaded openings as defined in DIN 6094-12:1995-10 (7.5 R) or DIN 6094-14:1995-02 (8 G), the contents of which are capable of building pressure; plastic screw cap closures (with or without a safety ring) for sealing returnable and disposable bottles made of glass or plastic, the contents of which are capable of building pressure.
Bottles are filled with mineral water and sealed with aluminum roll-on caps or plastic screw cap closures and tested. The samples are subjected to treatment in a light cabinet. Subsequently, the treated samples are tasted and compared to a reference sample.
Determination of the amount of cold break material in the pitching wort
Cast-out wort, wort from the midpoint of chilling/pitching wort (without yeast)
The hot break material (trub) and any hop particles which may be present in the wort, must first be removed. After the wort has been cooled to 2 °C, it is filtered through a glass fiber filter. The residue remaining on the filter is dried and then weighed.
Cold break material or cold trub refers to all material that settles out in the process of chilling wort after separation of the hot trub or hot break material. Cold trub can be filtered out of the wort and primarily consists of proteins (48–57 %), tannins (11–26 %) and carbohydrates (20–36 %). The amount of cold break material in wort depends on the quality and composition of the raw materials, brewhouse equipment and wort handling. In academic and professional circles, opinions regarding the significance of cold break material for downstream processes and for the quality of the finished beer are strongly divided [1, 2, 5]. Under certain circumstances, the quantity of cold break material in wort may exceed 250 mg/l, especially where accelerated fermentation is practiced. Ultimately, this can detract from the flavor of the finished beer [3]. Breweries, where removal of the cold break material has been practiced successfully, determine the quantity of cold break in their pitching wort at regular intervals, in order to evaluate the efficacy of their separation equipment.
Determination of the fermentation cellar yield in order to monitor brewhouse operations
Wort from the midpoint of chilling/pitching wort
The fermentation cellar yield is calculated using the value determined for the amount of extract contained in a batch of wort relative to the amount of extract present in the raw materials used to produce the wort.
The sample describes how to collect samples of adjuncts.
The moisture content of adjuncts is determined through the loss in mass during a standardized drying process, in which ground malt is dried at a defined temperature within a specified time in an electrically heated drying oven.
The moisture content is determined through the difference in the weight of the adjuncts prior to and after drying.
For samples with a moisture content greater than 17 % (for corn over 15 %), the sample has to be dried prior to conducting the analysis.