Hops and hop products intended for use in beer brewing or elsewhere in the food industry
A reliable sampling method for whole hops and hop products is a prerequisite for obtaining suitable material for analysis. The effort involved in collecting the sample depends upon how uniform the hop product is.
This method describes how to determine the moisture content of specialty malt.
Specialty malt intended for use in beer brewing or elsewhere in the food industry
Determination of xanthohumol and isoxanthohumol
All beers, beer-based beverages, wort, ethanol extracts, CO2 spent hops and xanthohumol products
Xanthohumol and isoxanthohumol are dissolved with acetonitrile from the sample and following separation, are determined using a Nucleodur C18 column and UV detection.
The cations in beer and wort are determined with this analysis.
This method is suitable for both wort and beer.
Inductively coupled plasma optical emission spectroscopy (ICP-OES) is a fast and reliable method for the laboratory analysis of metals. Inductively coupled plasma (ICP), a high frequency field of ionized gas, serves as a medium for atomizing and exciting the substances found in samples. Liquid, dissolved or aerosol samples are injected into the ionized gas stream. In emission spectroscopy, ICP can be used in conjunction with a number of optical and electronic systems either simultaneously or sequentially in multi-element spectrometers. In the plasma, the atoms and ions are excited to a higher energy state bringing about the emission of electromagnetic radiation (light), primarily in the ultraviolet and visible region of the spectrum. Metals ordinarily occur as ions in the temperature range typical for ICP of 6000 to 10000 K; however, non-metals and metalloids are only partially ionized.
ICP-OES operates within a very wide range. This usually encompasses six orders of magnitude in concentrations smaller than μg/l up to g/l, depending upon the element and the concentrations used for the set of analysis data. With ICP-OES, beer and wort can also be analyzed without prior processing of the samples, in contrast to AAS. Methods for determining the following in beer and wort will be described below: Al, B, Ba, Ca, Co, Cu, Fe, K, Mg, Mn, Mo, Na, P, Si, Sr, Sn and Zn.
This method is suitable for the determination of steam-volatile aroma compounds in wort.
Volatile aroma compounds are driven out of the sample through steam distillation. The ethanol distillate is adjusted to be alkaline and saturated with NaCl. The extraction of the aroma compounds is performed by shaking out with dichloromethane and the phases separated by centrifuging. The organic phase is further concentrated in a stream of nitrogen gas. An ammonia solution is added to remove the acids, because the acids would co-elute, thus preventing quantification of the target substances.
The method is suitable for beers of all original gravities and of any alcohol content.
The gas chromatography headspace method is used to determine the higher alcohols and esters present in beer, i.e., the volatile compounds are transferred from the headspace in the sample vial into the GC system for analysis. The following substances are measured in this analysis:
Acetaldehyde
Propanol-1
Ethyl acetate
2-Methylpropanol
3-Methylbutanol
2-Methylbutanol
2-Methylpropylacetate
Butyric acid ethyl ester
3-Methylbutyl acetate
2-Methylbutyl acetate
Hexanoic acid ethyl ester